Edge Short Loader Bar Feeders

Service "How-To" Videos

Bar Feeder How-To: Adjust Roller Steady On Minuteman 320 Bar Feeder

Steps to Adjust Roller Steady On Minuteman 320 Bar Feeder

1 - Load bar stock into bar feeder, lathe collet, and close

2 - Locate internat and external Roller Steady adjustment knobs

3 - Ensure spindle collet on lathe is in closed position

4 - Loosen 10mm nut on adjusting screw 5 - Push "Pre-Auto" on control panel to close roller steadies

Repeat steps on outer Roller Steady

Bar Feeder How-To: Zero Reference Minuteman 320 Bar Feeder

Steps to Zero Reference a Minuteman 320 Magazine Style Bar Feeder

1 - Make sure Bar Pusher is OFF Home Position

2 - Press and hold "Pre Auto" for 5 seconds

3 - Push button control for Pusher Position will read "0" "Zero"

4 - Home roller switch will be made

Bar Feeder How-To: Zero Reference Patriot 338 Bar Feeder

Steps to Zero Reference a Patriot 338 Bar Feeder

1 - Make sure Bar Pusher is OFF Home Position

2 - Press and hold "Forward" and " Reverse" simultaneously

3 - Touch screen will state "Zero Reference Finished"

4 - Home Prox switch turns ON

Bar Feeder How-To: Roller Steady Adjust an FMB Turbo 3-38 Bar Feeder

Steps to Adjust a Roller Steady on a Turbo 338 Bar Feeder

1 - Load bar stock into feed collet & lathe collet, clamped and on-center

2 - Remove housing door on nose-end of bar feeder by loosening 8mm set screws

3 - Enter MANUAL Mode on control panel [F7] (screen will confirm)

4 - Press F8 to close the Roller Steadies

5 - Locate Screw adjust knob towards back of nose housing

6 - Turn clockwise for larger bar material & counter clockwise for smaller material

7 - Test rollers with fingers to ensure optimal light roller tension

8 - Tighten lock screw on adjustment knob to maintain position

Bar Feeder How-To: Zero Reference FMB Turbo 3-38

Steps to Zero Reference a Turbo 3-38 Bar Feeder

1 - Make sure Bar Pusher if OFF the Zero Return approx. 6"

2 - Identify the Manual (F7) button and the Reference button (F1)

3 - Press the UP Arrow key and F1 Button simultaneously

4 - F1 light will turn green

5 - Pusher will move automatically to HOME Position

6 - Amber light will confirm process complete
Edge Technologies help email: edgehelp@edgetechnologies.com