Bar Feeder How-To: Zero Reference Patriot 338 Bar Feeder
Steps to Zero Reference a Patriot 338 Bar Feeder:
1 – Make sure Bar Pusher is OFF Home Position
2 – Press and hold “Forward” and ” Reverse” simultaneously
3 – Touch screen will state “Zero Reference Finished”
4 – Home Prox switch turns ON
More Videos
Installing Guide Channels on Patriot Gen II
Here, we demonstrate how to install guide channels on an Edge Technologies Patriot Gen II.[dvg_divi_video_gallery columns="1" _builder_version="4.27.4"...
Patriot 3-38 and 5-51 Guide Channel Setup Tutorial
In this instructional video, learn how to install a Guide Channel Set on a Patriot 338 and 551 Bar Feeder. We provide you with all the tips and tricks you will need, as...
Edge Patriot Jammed Channel Recovery
In this instructional video, we go over how to recover when a channel is closed on a pusher or when you receive a bar condition on an Edge Patriot Bar Loader....
Uninstalling Guide Channels on Patriot Gen II
Here, we demonstrate how to uninstall guide channels on an Edge Technologies Patriot Gen II.[dvg_divi_video_gallery columns="1" _builder_version="4.27.4"...
Patriot Extraction and Introduction Actuation Mechanism
Here, we demonstrate the Patriot Extraction and Introduction Actuation Mechanism on a Patriot 338 bar feeder.[dvg_divi_video_gallery columns="1"...
Bar Feeder How To – Removing Guide Channel on Patriot 3-38 and 5-51
Learn how to remove a Guide Channel Set on a Patriot 338 and 551 Bar Feeder. All it takes are 3, 5, and 10-mm hex allen wrenches, gloves and safety glasses....
Edge Patriot 338 Nose Alignment Procedure
Our Regional Service Manager Brian Grisez looks at the self-centering properties of a Patriot 338 MAVD, and performs a telescopic nose alignment. The goal is for the...
Edge Patriot Home Position Setting
In this instructional video, we go over the procedure for home referencing the pusher and also setting the home condition properly. It starts with making sure the right...