Bar Feeder How-To: Roller Steady Adjust an FMB Turbo 3-38 Bar Feeder
Steps to Adjust a Roller Steady on a Turbo 338 Bar Feeder
1 – Load bar stock into feed collet & lathe collet, clamped and on-center
2 – Remove housing door on nose-end of bar feeder by loosening 8mm set screws
3 – Enter MANUAL Mode on control panel by pressing F7 (screen will confirm this action)
4 – Press F8 to close the Roller Steadies
5 – Locate the Screw adjust knob towards back of nose housing
6 – Turn clockwise for larger bar material and counter clockwise for smaller bar material
7 – Test rollers with fingers to ensure optimal light roller tension
8 – Tighten lock screw on adjustment knob to maintain position
More Videos
FMB Turbo 3-38 RS by Edge Technologies
In this video, Regional Service Manager Brian Grisez demonstrates the new FMB Turbo 3-38 RS. This revolutionary machine will improve performance within the sliding...
FMB Indradrive Reset Procedure
In this instructional video, Regional Service Manager Brian Grisez describes how to perform a control reset, or Servo reset, on an FMB Bosch Indradrive-controlled Bar...
FMB Turbo 5-55 Channel Change
Edge Technologies demonstrates a channel change on an FMB 5-55. The FMB 5-55 boasts one of the fastest channel changes in the CNC lathe automation industry....
FMB Turbo 5-65 Roller Steady Air Regulator Adjustment
Here, we walk through a roller steady Festo air regulator adjustment on an FMB Turbo 5-65.[dvg_divi_video_gallery columns="1" _builder_version="4.27.4"...
FMB Turbo 4-45 RS-V
[dvg_divi_video_gallery columns="1" _builder_version="4.27.4" _module_preset="default" global_colors_info="{}"][dvg_divi_video_gallery_item...
FMB Telescopic Nose Alignment Procedure
[dvg_divi_video_gallery columns="1" _builder_version="4.27.0" _module_preset="default" global_colors_info="{}"][dvg_divi_video_gallery_item...
FMB Turbo 20-100 Channel Change
[dvg_divi_video_gallery columns="1" _builder_version="4.27.4" _module_preset="default" global_colors_info="{}"][dvg_divi_video_gallery_item...
FMB Pusher Closed on Bar Recovery
In this instructional video, Regional Service Manager Brian Grisez goes over how to recover from a pusher swing closed on a bar or foreign object on an FMB bar feeder...
Bar Feeder How To – Programming The Turbo 3-38 HMI
In this video we show you some quick steps on programming your HMI for the FMB Turbo 3-38 Bar Feeder, starting with the top left Menu icon, and moving to the Program...
FMB Turbo Anti-Vibration Roller Adjustment
Here, we show how to adjust the rollers on the anti-vibration device for an FMB Turbo 5-65 Auto Adjust bar feeder. This also works on FMB Turbo 3-38, FMB Turbo 5-55,...