Other Videos
Other Helpful Sources
Why Is My Remnant So Long? Part 3
Part 3 of an instructional video series describing remnant length related to bar fed Swiss machine applications. If you haven't watched Part 1 and 2, start with those....
Installing Guide Channels on Patriot Gen II
Here, we demonstrate how to install guide channels on an Edge Technologies Patriot Gen II.[dvg_divi_video_gallery columns="1" _builder_version="4.27.4"...
Bar Feeder How-To: Adjust Roller Steady On Minuteman 320 Bar Feeder
Adjust the Roller Steady on a Minuteman 320 bar feeder Steps: 1 - Load bar stock into bar feeder, lathe collet, and close 2 - Locate internal and external Roller Steady...
FMB Pusher Closed on Bar Recovery
In this instructional video, Regional Service Manager Brian Grisez goes over how to recover from a pusher swing closed on a bar or foreign object on an FMB bar feeder...
Vortex Installation and Operation
Transcript of Vortex Installation and Operation: Hello, welcome to Edge Technologies. My name is Jason Bell, regional service manager of the West Coast, and I'm here...
Why Is My Remnant So Long? Part 4
This is part 4 in my ongoing series of videos describing the remnant length of bar fed machining applications. In this video we look at fixed headstock lathes and talk...
Edge Patriot Home Position Setting
In this instructional video, we go over the procedure for home referencing the pusher and also setting the home condition properly. It starts with making sure the right...
Bar Feeder How-To: Roller Steady Adjust an FMB Turbo 3-38 Bar Feeder
Steps to Adjust a Roller Steady on a Turbo 338 Bar Feeder 1 - Load bar stock into feed collet & lathe collet, clamped and on-center 2 - Remove housing door on...
FMB Turbo Anti-Vibration Roller Adjustment
Here, we show how to adjust the rollers on the anti-vibration device for an FMB Turbo 5-65 Auto Adjust bar feeder. This also works on FMB Turbo 3-38, FMB Turbo 5-55,...
Bar Feeder How-To: Zero Reference Minuteman 320 Bar Feeder
Steps to Zero Reference a Minuteman 320 Magazine Style Bar Feeder 1 - Make sure Bar Pusher is OFF Home Position 2 - Press and hold "Pre Auto" for 5 seconds 3 - Push...